Items/Model	TS500(PLC)
Picture
Principle	Waste Incineration Treatment
Burn Rate	150-200 kg/hour
Control Mode	PLC(Programmable Logic Controller Incinerator)
Combustion Chamber	2700L
Internal Dimensions	190x120x120cm
Secondary Chamber	1300L
Smoke Filter Chamber	Yes
Feed Mode	Manual
Voltage	220V
Oil Consumption (kg/hour)	Average 28
Gas Consumption (m3/hour)	***
Temperature Monitor	Digital Display
Temperature Protection	Yes
Oil Tank	1400L
Feed Door	90x80cm
Chimney	10Meter
Chimney Type	Stainless Steel
1st. Chamber Temperature	800℃–-1000℃
2nd. Chamber Temperature	1000℃-1200℃
Residency Time	2.0 Sec.
Gross Weight	15000kg
External Dimensions	400x210x300cm(without chimney)

The air supply should be controlled efficiently;

Flame contact with all the gases should be achieved;

The minimum combustion temperature of the primary chamber should not be less than 850°C;

The primary combustion chamber should be equipped with a means to provide supplemental liquid fuel supply.

The primary chamber should be cold face refractory lining, with a minimum thickness 100 mm.

The following conditions should be met in the secondary combustion chamber:

The air supply should be controlled efficiently;

Flame contact with all the gases should be achieved;

The size of the secondary chamber should be properly designed to ensure that the gas retention time should not be less than 2 seconds;

The secondary chamber should be cold face refractory lining, with a minimum thickness 100 mm;

The chamber should incorporate an integrated combustion burner air fans with automatically controlled distribution;

The gas temperature, as measured against the inside wall in the secondary chamber (not in the flame zone) should not be less than 1,100°C;

HICLOVER – Medical Environmental 

---

 

WWW.HICLOVER.COM

Waste Incinerators

Medical Waste Incinerator

Pet Animal Cremation

Solid Waste Incinerator

Tel:  +86-25-8461 0201   

Mobile: +86-13813931455(whatsapp/wechat)
Website: www.hiclover.com  
Email: [email protected]
Email: [email protected]  

Nanjing Clover Medical Technology Co.,Ltd.

 

2020-03-21